Extreme Networks ExtremeSwitching X440-G2 Series User Manual

•
RJ45 Ethernet management port.
•
USB port for access to external storage.
•
USB console port.
•
RJ45 RS-232c serial console port used to connect a terminal and perform local management.
•
LEDs to indicate port status and switch operating conditions. For a description of the LEDs and their
operation, see ExtremeSwitching X870 Series Switch LEDs on page 89.
Figure 95: ExtremeSwitching X870-96x-8c Front Panel
1 = Precision Timing ports (not supported) 4 = QSFP28/QSFP+ Ethernet ports
2 = Storage port: micro USB A 5 = Console port: RJ45
3 = Console port: micro USB B 6 = Ethernet management port: RJ45
The rear panel of the ExtremeSwitching X870-96x-8c switch includes:
•
Six replaceable fan modules.
•
Two power supply bays for either AC or DC power supplies.
Figure 96: ExtremeSwitching X870-96x-8c Rear Panel
1 = Grounding lug
3 = AC power supplies
2 = Fan modules
ExtremeSwitching X870 Series Switch LEDs
The following sections describe the meanings of the LEDs on the ExtremeSwitching X870 series
switches.
ExtremeSwitching Switches
ExtremeSwitching and Summit Switches: Hardware Installation Guide 89

Extreme Networks ExtremeSwitching X440-G2 Series Specifications

General

Form Factor	Rack-mountable
VLAN Support	Yes
Humidity	5% to 95% non-condensing
Model	X440-G2 Series
Port Type	Gigabit Ethernet
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
Stacking	Yes, up to 8 switches
Layer Support	Layer 2/3
Operating Temperature	0°C to 50°C
Product Type	Switch
Jumbo Frames	9216 bytes
AC Power Supply	100-240 VAC, 50-60 Hz
Storage Temperature	-40°C to 70°C
Port Configuration	24 or 48 ports
Power over Ethernet (PoE)	Optional