Software- and Web Page-based Setup and Control, cont’d
4-22
PRELIMINARY
MLC 226 Series • Software-and Web Page-based Setup and Control
Real-Time Adjustments
The Real-Time Adjustments tab, shown below, allows you to make adjustments
without having to use the front panel controls, and it provides access to settings not
available via the front panel.
A typical Real-Time Adjustments tab
In this part of the program you can:
• Set an MLS switcher’s per-input audio level (see instructions on the next
page).
• Make overall bass and/or treble adjustments for an MLS switcher.
• Adjust overall volume.
• Choose between stereo and mono output for the Preamp output of an MLS
switcher that features an amplifier.
• Select either 4 ohm or 8 ohm speaker load for the optional MLS switcher’s
amplified output, if applicable for the model connected. Wiring must also
correspond to the setting.
• Set the video format: composite video/S-video or component for some switcher
models.
Video output may turn off briefly (for the duration of the RGB delay setting)
while you set the video configuration.
• Set the RGB delay period (for Triple-Action
™
Switching) for an MLS switcher.
• Configure miscellaneous options such as display/projector power-up/-down
delay periods, automatic shutoff periods, and special projector or output
settings.
• Reset the MLS switcher’s settings to factory default settings.
If logged in as a user rather than an administrator, you are able to change
overall volume only. Other settings may not be changed by anyone without
administrator privileges.
To Next Page
Loading...
Need help?
General
