4-37
PRELIMINARY
MLC 226 Series • Software-and Web Page-based Setup and Control
Scheduling
The Scheduling tab makes it possible to automatically turn projector power on
and off once on specific days of the week. Scheduling operates as a simple timer
that tells the controller when to send projector on/off commands.
The Scheduling tab during setup
Scheduling cannot be set up if there are pending changes to the
configuration file. You must build and apply the configuration before
setting up scheduling.
1. Select the Scheduled check box for the Power Display On function.
2. Select the check box(es) next to the desired day(s) of the week to
automatically turn the projector on.
3. Click on the up/down arrows next to/in the At: box (below the Scheduled
check box) to select the time of day for projector power-on.
This part of the program uses a 24-hour time scheme. There is no selection for
a.m. and p.m.
4. Repeat steps 1 through 3 for the Power Display Off function.
5. Click the Take button.
To Next Page
Loading...
Need help?
General
