A952 34 532310 - Rev.A
4
2
2
4
1
3
3
a
b
a
b
16
6
10 Nm
6
10 Nm
■ INSTALLING THE ARM
With reference to 16:
1. Slide the shoe into the guide.
2. Install the covers at the ends of the guide and fasten them using the grub screws.
3. Fasten the shoe horizontally at the ends using the screws supplied (metric "a" or self-tapping "b" for wood)
in correspondence with the holes or the points that were previously marked as indicated in the installation
diagram for the specific application (1- 7). The slotted sides of the side covers should face the surface
on which they will be fixed.
4. Press the side covers onto the guide.
5. Keep the door closed and slide the shoe inside the guide until it is possible to connect the arm to the
gearmotor.
To Next Page
Loading...
