FAAC A952 - Page 37

A952 35 532310 - Rev.A
17
13
20 Nm

13
20 Nm
18
19
2
3
4
1
2
1
3
5
6
7
8
7
8
2
3
4
1
2
3
4
1
H50
H80
■ CONNECTING THE ARM TO THE OPERATOR
- NO SPACER (17)
1. Insert the arm directly onto the shaft of the operator.
2. Insert the washer (1), disc spring washer (2) and screw (3) (use the screw supplied with the arm) and then
tighten to a torque of 20 Nm.
L
Make sure that you install the disc spring washer as shown in 18-2.
3. Press the cover on (4).
4. In the opening by spring application, remove the cam that was inserted previously (15-1).
- WITH SPACER H50/H80 (19)
1. Remove the bush (5) and the grooved insert (6) from the arm.
2. Install the arm on the operator shaft, interposing the spacer (7) and its grooved insert (8).
3. Insert the washer (1), disc spring washer (2) and screw (3) (use the screw supplied with the spacer) and
then tighten to a torque of 20 Nm.
L
Make sure that you install the disc spring washer as shown in 18-2.
4. Press the cover on (4).
5. In the opening by spring application, remove the cam that was inserted previously (15-1).