Fagor BCSD Series - Page 109

Digital Brushless AC Servo Drive system - Ref. 1809 BCSD-109/116
Parameter
No.
Description
Setting
Validation
Function and Meaning
Pn511
Output signal
allocation
After restart
Pn511.0 corresponding port CN1_11, CN1_12
Pn511.1 corresponding port CN1_05, CN1_06
Pn511.2 corresponding port CN1_09, CN1_10
Corresponding signal of each data is shown as follows:
0: /COIN/VCMP
1: /TGON
2: /S-RDY
3: /CLT
4: /BK
5: /PGC
6: OT
7: /RD
8: /HOME
Pn512
Bus control
input
node low-bit
enabled
Immediately
Bus communication input port enabled:
[0]: Disabled
[1]: Enabled
Pn512.0  CN1_14
Pn512.1  CN1_15
Pn512.2  CN1_16
Pn512.3  CN1_17
Pn513.0  CN1_39
Pn513.1  CN1_40
Pn513.2  CN1_41
Pn513.3  CN1_42
Pn513
Bus control
input node low-
bit enabled
Immediately
Pn514 Input port filter Immediately
It is used to set input port filter time. The signal will be lagged
if the parameter setting is too high.
Pn515 Reserved
Pn516
Input port signal
inversion
Immediately
[0]: Do not inverse signal.
[1]: Inverse signal
Pn516.0  CN1_14 inversion
Pn516.1  CN1_15 inversion
Pn516.2  CN1_16 inversion
Pn516.3  CN1_17 inversion
Pn517.0  CN1_39 inversion
Pn517.1  CN1_40 inversion
Pn517.2  CN1_41 inversion
Pn517.3  CN1_42 inversion
Pn517
Input port signal
inversion
Immediately
Pn518 Reserved Immediately For factory using
Pn519 Reserved Immediately For factory using
Pn520 Reserved Immediately For factory using
Pn521 Binary Immediately
If connect externally regenerative resistor
0: connect externally regenerative resistor between B1 and
B2.
1: dose not connect externally regenerative resistor, relay on
internal capacitance.
Pn522 Reserved — —
Pn523 Reserved — —