FENDT 926 Vario User Manual

39
OPERATION
7.4 Driving mode selector
Operation_Pic_number:1
The currently selected mode is indicated by a
spot (A). The selected mode is indicated by a
flashing spot.
Text-module
● The driver can use button (M) to switch from
range I to range II.
NOTE:
The last range selected is always set, even af-
ter turning the ignition on or off.
Text-module
RANGE I (field)
For heavy field use at a speed of:
0.02 - 32 km/h forward.
0.02 - 20 km/h in reverse.
Text-module
RANGE II (road)
For fast transport at speeds of:
0.02 - 50 km/h forward.
0.02 - 38 km/h in reverse.
Text-module
WARNING:
When selecting driving mode,
tractive power is interrupted. Do not
use on slopes (uphill or downhill).
Fig.52
Switching when tractor stationary
● Select Neutral position or
● operate clutch pedal.
● Select the desired mode.
Text-module
Selecting driving mode I or II while
travelling
Driving mode selection is not possible if:
● Neutral position is engaged.
● Transmission oil temperature below 10°C.
● Engine brake actuated.
Text-module
Switching from operating range II to I
when travelling
Driving mode selection is not possible if:
● Ground speed over 20 km/h.
● Neutral position is engaged.
● Engine speed over 2300 rpm.
● Transmission oil temperature below 10°C.
● Engine brake actuated.
NOTE:
In unfavourable conditions, e.g. cold weather,
selecting a driving mode may simply cause
the neutral position to be selected. Interrup-
tion of tractive power, repeat driving mode
selection with button (M/ OPERATION
Fig. 52).
Cruise control and Quick Reverse function
deactivated.

FENDT 926 Vario Specifications

General

Engine Power	260 hp
Transmission	Vario continuously variable transmission
Fuel Tank Capacity	500 liters
Weight	10, 500 kg
Engine type	6-cylinder turbocharged
Rated engine speed	2100 rpm
Displacement	7.5 liters
Number of cylinders	6
Maximum speed	50 km/h
Tire Options	Multiple options available