FENDT 926 Vario User Manual

49
OPERATION
Operation_Pic_number:1
A = Current fuel consumption.
B = Average fuel consumption.
Measurement at tractor START or
Press button (F3). Display is reset to '0'.
C = 1. Unit counter (e.g. for comparing the
same operation when different driving
styles are used).
Measurement at tractor START or
Press key (F4). Display is reset to '0'.
D = 2nd sum counter (e.g. comparisons of
the same work done with different dri-
ving methods).
Measurement at tractor START or
Press key (F5). Display is reset to '0'.
Text-module
NOTE:
Maximum value for the sum counter is
30000 litres, then measuring starts at 0 again.
Fig.79
9. Tractor Management
System (TMS)
Text-module
MODE 1
Joystick - engine management system off
The transmission ratio is set with the joystick, the
engine speed is set with the accelerator.
Text-module
MODE 2
Joystick - engine management system on
Driving speed is set with the joystick; the engine
speed and transmission ratio are set automati-
cally.
NOTE:
If the TMS is active and change of direction is
programmed, the speed is taken up indepen-
dent of the engine speed.
Text-module
MODE 3
Accelerator - engine management system off
The transmission ratio and the engine speed are
set with the accelerator.
Text-module
MODE 4
Accelerator - engine management system on
Driving speed is set with the accelerator; the en-
gine speed and transmission ratio are set auto-
matically.
NOTE:
If TMS is active and there is a programmed
change of travel direction, only the current
speed is obtained.

FENDT 926 Vario Specifications

General

Engine Power	260 hp
Transmission	Vario continuously variable transmission
Fuel Tank Capacity	500 liters
Weight	10, 500 kg
Engine type	6-cylinder turbocharged
Rated engine speed	2100 rpm
Displacement	7.5 liters
Number of cylinders	6
Maximum speed	50 km/h
Tire Options	Multiple options available