Festo FB13 - Service

This manual describes the operation of the Festo
valve terminals types 03-05 in conjunction with
the field bus protocols PROFIBUS-DP as per EN
50170 (DIN 19245).
PLEASE NOTE
In conjunction with a Siemens SIMATIC S5,
both the SINEC L2-DP and the PROFIBUS-
DP protocols can be used; in conjunction with
other PLCs, PCs, industrial PCs, the
PROFIBUS-DP protocol must be set.
In this manual, the protocol variants are desig-
nated as follows:
– DP-standard for PROFIBUS-DP
– DP-Siemens for the SINEC L2-DP.
The valve terminal does not contain the
PROFIBUS-FMS protocol (no combi-slave
functions).
Service
If you have any technical problems, please
consult your local Festo Service.
VIFB13 - 03/05 General safety instructions
XVI
9701 NH