Operator‘s Manual for instrument types MP0R 5
Switching the Instrument ON / OFF
Manually Switch-Off
Before you start
The instrum
ent must be in the measuring mode: the display shows the
last measurement.
Procedure
• Press the [OK] button for about 2 seconds. The instrument switched off
and the display is blank and dark.
Switching off the instrument manually, always activates the Auto-Switch-
Off function. Switch-on only the instrument only by pressing the [OK] but-
ton the Auto-Switch-Off function is activated again as set in the service
menu 4 (OFF1 or OFF2, 37).
Deactivate Auto-Switch-Off
The instrument does not switch off automatically after a certain time. It will
be switched on as long as the instrument is switched-off manually.
5, switching off the instrument manually and activate the Auto-Switch-
OFF function.
Before you start
The instrument is switched off.
Procedure
1. Press the button [OK] while pressing the button [ESC]. The instrument
switched on.
2. Release the button [ESC] not until the last measurement value appears
in the displays.
The instrument is ready for measurements.
To Next Page
Loading...
