6 Operator‘s Manual for instrument types MP0R
Measurement
3 Measurement
Before you start
Switch the instrument ON by pressing the key [OK] .
For instrument models MP0R only: Remove the orange protective cap
from the probe.
Procedure
1. Place the instrument/probe on the specimen and wait until the acoustic
signal sounds and the signal LED illuminates. The measurement will
be displayed.
2. Lift the instrument/probe off the specimen before making the next mea-
surement. Minimum distance 25 mm.
Measuring with instrument models MP0R
Handling the probe of the instrument models MP0R-FP
Coated specimen
Measurement capture
Measurement capture
Coated specimen
To Next Page
Loading...
