FISCHER PERMASCOPE MP0R - Transmitting the mean value to the PC

Operator‘s Manual for instrument types MP0R 25
Data Transmission
Transmitting all measurement data to the PC after measurement
Before you start
USB driver is installed on the computer where the instrument will con-
nected.
The instrument is connected at the computer via the USB cable.
The instrument is turned ON ([OK] key).
The program on the computer to which the data will transmitted is
open. Attend the manual of the program for data import.
Procedure
1. Set the display menu with [] or [] to show .
2. Press button [OK]. 
All readings in the memory are then transmit to the PC.
8.3 Transmitting the mean value to the PC
Transmitting the mean value manually to the PC after measure-
ment
Before you start
USB driver is installed on the computer where the instrument will con-
nected.
Please Note!
No transmission of single readings in the measuring mode SSPC.
Please Note!
Only available for measuring mode Std.
PRT
MP0R_DataTrans_en.fm Seite 25 Donnerstag, 24. März 2011 6:46 18