Operator‘s Manual for instrument types MP0R 31
Instrument Settings
The menus 2, 6 to 8 and 10 to 12 are not callable and for service purposes
only.
9.1 Access to the instrument setting menus
Before you start
Instrument must be switched ON by pressing the key [OK].
Procedure
1. Set the display menu with [] or [] to show .
2. Press button [OK]. "157" will appear on the display.
3. Set "159" using the key [].
4. Press button [OK]. " " will appear on the display.
5. Select the desired menu number using [ ] or [ ].
6. Press button [OK] repeatedly to select the menu features.
7. Set the current setting using the key [] or [].
8. Press button [OK] to save the setting.
9. Press button [ESC] to leave the setting routine at any time. If you have
modified an instrument setting, this will be saved automatically.
Group separator triggering enable/disable 4 37
Auto-switch Off, time setting (approx. 1 or 5 minutes) 4 37
Display illumination on/off 4 38
Free-Running display mode enable/disable (continuous
display of the readings)
539
Factory reset (all settings in the instrument setting
menus are set back to the factory settings)
940
Settings/selections in the instrument setting
menus
Para-
meter
Menu
no.
Page
To Next Page
Loading...
