28 Operator‘s Manual for instrument types MP0R
Data Transmission
8.4 Triggering the group separator to the PC
The group separator separates the different measurement blocks at the
data transmission. In an Excel spreadsheet the group separator has the
effect of writing the succeeding single readings of the next measurement
block in a new column next to the one that has just been processed.
Triggering the group separator manually to the PC
Before you start
USB driver is installed on the computer where the instrument will con-
nected.
The instrument is connected at the computer via the USB cable.
The instrument is turned ON ([OK] key).
For instrument models MP0R only: Remove the orange protective cap
from the probe.
Settings of service menu 1 must be bL = 0. Procedure 31 and 33.
Settings of service menu 4 (Procedure 31 and 37) must be
SI = 1 or 0 (mode Std only; 1 = only single readings, 0 = only mean val-
ues are transmitted),
GS = 1 (group separator is active).
The program on the computer to which the data will transmitted is
open. Attend the manual of the program for data import.
Procedure
1. Make the desired number of measurements.
2. Set the display menu with [ ] or [ ] to show and press button [OK]
to the statistics computation.
Please Note!
Not available in measuring mode SSPC.
MP0R_DataTrans_en.fm Seite 28 Donnerstag, 24. März 2011 6:46 18
To Next Page
Loading...
