24 Operator‘s Manual for instrument types MP0R
Data Transmission
8.2 Transmitting measurements
Transmitting only the current reading while measurment
Before you start
USB driver is installed on the computer where the instrument will con-
nected.
The instrument is connected at the computer via the USB cable.
The instrument is turned ON ([OK] key).
Mode Std: Settings of service menu 4 must be SI = 1 (single reading
transmission is active, only single readings will then be transmitted).
Procedure 31 and 37.
Mode 90.10: default setting, always single readings are transmitted.
For instrument models MP0R only: Remove the orange protective cap
from the probe.
The program on the computer to which the data will transmitted is
open. Attend the manual of the program for data import.
Procedure
Each reading is transmit to the computer automatically with every
measurement capture. At the same time, the reading is accepted into the
measurement data memory of the instrument and can be evaluated statis-
tically.
Please Note!
No transmission of current reading in the measuring mode SSPC.
MP0R_DataTrans_en.fm Seite 24 Donnerstag, 24. März 2011 6:46 18
To Next Page
Loading...
