FISCHER PERMASCOPE MP0R - Display Resolution - Menu 1; Data Storage - Menu 1; Dimension Unit - Menu 3

34 Operator‘s Manual for instrument types MP0R
Instrument Settings
Display resolution - Menu 1
Number of numerals after the decimal point in the display.
Call up instrument
setting menu 1 see description on page 31.
Data storage - Menu 1
Enable/disable the data storage in the instrument. The single readings and
the e
valuation of one block (last block) can be stored in the instrument.
Call up instrument setting menu 1 see description on page 31.
Dimension unit - Menu 3
Set the unit of measurement.
Call up instrument
setting menu 3 see description on page 31.
Mode Default setting Further settings
Std,
SSPC,
90.10
= low resolution: 0.0
= medium resolution: 0.00
= high resolution: 0.000
Mode Default setting Further settings
Std
= data storage enabled = data storage disabled
SSPC,
90.10
data storage always enabled for
this modes.
not available - fixed instrument
setting, not changeable
Mode Default setting Further settings
Std,
SSPC,
90.10
= µm = mils
/