Operator‘s Manual for instrument types MP0R 21
Specification Limits / Offset value
Before you start
Instrument must be turned ON by pressing the key [OK].
For instrument models MP0R only: Remove the orange protective cap
from the probe.
Procedure
1. Set the display menu with [] or [] to show .
2. Press button [OK]. The message "MIN" appears on the display.
The instrument await the entry for the lower specification limit.
3. Make one measurement on the specimen to be tested to get a approx-
imate value for the lower specification limit.
4. Set the desired MIN value using the key [] or [].
90.10 measuring mode active: continue with step 10. In this mode a
lower limit specification value can be set up only.
5. Press button [OK] to accept this value into the memory.
The message "MAX" appears on the display. The instrument await the
entry for the upper specification limit.
6. Make one measurement on the specimen to be tested to get a approx-
imate value for the upper specification limit.
7. Set the desired MAX value using the key [] or []
.
SSPC measuring mode active: continue with step 10. In this mode a
lower and upper limit specification value can be set up only.
8. Press button [OK] to accept this value into the memory. The message
"OFFS" appears on the display. The instrument await the entry for an
offset-value.
An offset-value will be subtracted automatically from the readings.
Application example: Having a given, constant thickness of an interme-
diate layer, you can set this thickness as “offset”. The thickness of both
coatings are measured. In this case, only the thickness of the top coat-
ing will be displayed because of the subtracted offset value from the
captured measurement.
9. Set the desired OFFS value using the key [] or []. Value 0.00 means
no Offset value set.
To Next Page
Loading...
