Flashforge Creator3 - Page 67

Creator3 User Guide | www.flashforge.com 400-699-1063
67
Method 2：Connect Via WiFi
①
Connect Creator3 with your PC under AP mode
a.Turn on your Creator3
b. Tap [Tools]-[Setting]-[WLan hotspot]-[WLan hotspot ON].
c. Click on the wireless network setting in your computer, and find the wireless
signal-“Creator3”. Click [Connect] to connect your computer with Creator3 via Wlan
hotspot.
d. Click [Print]-[Connect Machine] on FlashPrint. Then the following dialog
box pops up. You need to select “Wi-Fi” in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].