Creator3 User Guide | www.flashforge.com 400-699-1063
If successfully connected, you will see the following mark on the right corner.
②Connect Creator3 with your PC under STA mode
a. Tap [Tools]-[Setting]-[WiFi]-[WiFi ON] to turn on the WiFi of Creator3 and
connect your computer and Creator3 with the same WiFi signal.
b. Click [Print]-[Connect Machine] on FlashPrint. Then the following dialog
box pops up. You need to select “Wi-Fi” in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].
If successfully connected, you will see the following mark on the right corner.
Disconnect Creator3
Click [Print]--[Disconnect] to disconnect your PC and Creator3.
To Next Page
Loading...
