Flexball Italiana S.r.l. 28
6.8. Trim/Flap option
Flap/trim command can be activated directly from the command station with the buttons ‘+’ and ‘-’. The
commands are sent to the actuator from the command station. The relay card fitted on the actuator box
activates the flap/trim commands on the hydraulic pump.
For installations with two engines, in case of “Synchro” mode operation, the buttons on the right-hand side
operate the trims of both engines simultaneously.
Command station series 3500
Command station series 4500
1 motor version
Trim or flap can be activated directly from the command station with “+” and “-“
pushbuttons. These pushbuttons are placed on the lateral side of the left lever.
2 motors version
1 engine version
2 engines version
Trim or flap are tuned with “+” and “-“
pushbuttons placed on the keypad (a
couple for each motor).
It is also possible to command in
sychro trim or flap of both motors with
the “+” and “-“ pushbuttons placed on
the lateral side of the left lever.
This feature is very comfortable during
navigation.
To Next Page
Loading...