Flexball Italiana S.r.l. 63
18. Programming of actuators with electronic CANBUS motor and
electronic gearbox
18.1. CANBus motor parameters
For parameter setting, please refer to section 17.2.
18.2. Electronic gearbox parameters
For parameter setting, please refer to section 15.2.
18.3. Wiring of the actuator outgoing cables
For wiring of the cables outgoing from the actuator refer to section 10.2.
19. Programming of actuators for installations with Trim or Flap
command option
For trim or flap option it isn’t necessary any programming. Refer to the specific instructions for the actuators
configured for their basic installation (without the trim option), as described in sections from 13. to 18. included.
Use electrical cables between actuator and trim pump or from actuator and flap pump as specified in sections
6.4, 6.5. and 10.2.2. Verify that wiring is according to electrical scheme reported at section 10.2.3.
To Next Page
Loading...