Flexball Italiana S.r.l. 68
22. How to start
Once you have received the system package, follow these steps:
1) identify all the components necessary to build up your system with the help of instructions at
sections 4,5,6
2) identify your installation type with the help of section 7.
3) configure the CANBus network, set dip-switches and end of line termination of actuators and
command stations, as described at section 8
4) mount command stations and actuators with the help of drilling mask (section 23)
5) make electrical wiring (section 10)
6) install push-pull cables, if your application requires it (section 9)
7) make setting of mechanical strokes, if your application requires it (section 12)
8) program the actuator specific installation parameters (from section 13 to section 18 included)
9) make the programming of the options, if your application requires it (sections 19 and 20)
10) once you have set-up the electronic system, read the pilot instruction (section 3) and, good
navigation!
To Next Page
Loading...