Flowserve Limitorque Accutronix MX - Page 5

Table of Contents/Figures
Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
5.7.1 Removal 5-31
5.7.2 Remounting 5-31
5.8 Motor Lead Harness (MX-85 & 140 only) 5-32
5.8.1 Removal 5-33
5.8.2 Remounting 5-34
6 Spare & Replacement Parts 6-1
6.1 Guidelines for Recommended Spare Parts 6-1
6.1.1 Wear Components 6-1
6.1.2 Bearings, O-Rings, & Seals 6-1
6.1.3 Critical Components 6-1
6.2 Recommended Spare Parts 6-2
6.2.1 Commissioning & Startup 6-2
6.2.2 Short-Term Duty 6-2
6.2.3 Long-Term Duty 6-2
6.2.4 Severe Duty 6-2
6.3 Other Concerns 6-3
7 Regulatory Information 7-1
Figures
Figure 2.1 – Accutronix MX-05 Actuator 2-1
Figure 2.2 – Accutronix MX Nameplate 2-3
Figure 2.3 – Oil Fill/Plug Locations for Side-Mounted & Top-Mounted Handwheels 2-4
Figure 4.1 – Motor (MX-05, 10, 20, & 40) 4-1
Figure 4.2 – Declutch (MX-05 & 10) 4-4
Figure 4.3 – Declutch (MX-20 & 40) 4-5
Figure 4.4 – Declutch (MX-85 & 140) 4-6
Figure 4.5 – Top-Mounted Handwheel (MX-05, 10, 20, & 40) 4-10
Figure 4.6 – Side-Mounted Handwheel (MX-10 & 20) 4-12
Figure 4.7 – Side-Mounted Handwheel (MX-85 & 140) 4-13
Figure 4.8 – Side-Mounted Handwheel with SGA (MX-40) 4-17
Figure 4.9 – Side-Mounted Handwheel with SGA (MX-85 & 140) 4-18
Figure 4.10 – Type A1 Thrust Base (MX-05) 4-30
Figure 4.11 – Type A1 Thrust Base (MX-10, 20, & 40) 4-31
Figure 4.12 – Type A1 Thrust Base (MX-85)- F16 Flange 4-32
Figure 4.13 – Type A1 Thrust Base (MX-140)- F25 Flange 4-33
Figure 4.14 – Type B1 Torque Base (MX-05, 10, 20, & 40) 4-35
Figure 4.15 – Type B4 Baseplate (MX-05, 10, 20, & 40) 4-37
Figure 4.16 – Type B4 Baseplate (MX-85 & 140) 4-37
Figure 4.17 – Worm Shaft (MX-05, 10, 20, & 40) 4-39
Figure 4.18 – Drive Sleeve (MX-05 & 10) 4-42
Figure 4.19 – Drive Sleeve (MX-20 & 40) 4-44
Figure 4.20 – Drive Sleeve (MX 85 & 140) 4-44
Figure 4.21 – Handwheel Adapter (MX-05) 4-49
Figure 4.22 – Handwheel (MX-05) 4-50
Figure 4.23 – Handwheel Adapter Assembly 4-53
Figure 4.24 – Handwheel Worm Gear Assembly 4-54
Figure 4.25 – Clutch & Clutch Ring Components (MX-20 & 40) 4-59
Figure 4.26 – Clutch & Clutch Ring Components (MX-85 & 140) 4-59
Figure 4.27 – Clutch Ring (MX-85 & 140) 4-62
Figure 5.1 – Accutronix Control Panel 5-1
Figure 5.2 – Control Module 5-4
Figure 5.3 – Location of fuses and voltage jumper 5-12
Figure 5.4 – Standard Board Set 5-12
Figure 5.5 – Standard Board Set with DDC Option 5-13
VII
Flow Control Division
Limitorque Actuation Systems