Accutronix MX Maintenance & Spare Parts Manual 130-12000 Revision B • November 2002
STEP 5
Once handwheel adapter assembly is installed in actuator housing,
wind wave spring (#1-10) into groove on the handwheel adapter.
STEP 6
Slide handwheel spacer (#1-9) over handwheel adapter assembly,
ensuring wave spring (#1-10) is seated in groove of the handwheel
spacer.
STEP 7
Remount all removed subassemblies according to the
remounting instructions in the following order:
1. Drive sleeve (subassembly #2). (See Section 4.11.2.)
2. Base plate (subassembly. #11). (See Section 4.9.2.)
3. Worm shaft (subassembly. #3). (See Section 4.10.2.)
4. Motor (subassembly #4). (See Section 4.1.2.)
5. Top-mounted handwheel (#1-8). (See Section 4.3.2.)
NOTE: After completing handwheel assembly procedure, turn handwheel enough to ensure wave
spring is not pinched between actuator housing and handwheel spacer. If it is pinched, remove
handwheel (#1-8) and handwheel spacer (#1-9) to reseat the wave spring (#1-10) into the grove on the
handwheel spacer. Install handwheel.
6. Add oil.
4-52
Flow Control Division
Limitorque Actuation Systems
Mechanical Assemblies
5
6
1-10
1-9
1-10
To Next Page
Loading...
