25-1
Chapter 25
Using Memory and PC
Introduction
This chapter explains how to save screens and data into the Analyzer’s memory and how
to view, rename and delete them.
The second part of the chapter explains how to setup the Analyzer for communication
with a PC, and laptop.
Using memory
Four types of data can be stored:
1. Save Limits: these contain Power Quality limits and thresholds. Limits can be edited
via SETUP, F4 – MANUAL SETUP and Adjust Limits menu.
2. Save Task: tasks include limits and analyzer setups. Setups include the reading
selections made for the Logger measurement.
3. Save Screen: are stored when operating the SAVE SCREEN key.
4. Measurements: they are automatically saved on the SD Card during the measurent.
Measurement data includes all trend data, the task and the limits of the measurement.
Additionally the screen shown when the measurement was stopped is included.
Memory space depends on the size of the installed SD Card. The maximum supported
size of the card is 32 GB.
The data files are numbered automatically.
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca
To Next Page
Loading...
Need help?
General
