19-1
Chapter 19
Power Wave
Introduction
In this measuring mode that is available in Fluke 435-II and 437-II the Analyzer
functions as an 8 channel scope recorder that records high resolution waveforms in a
single shot acquisition. The function records half cycle rms values on 8 channels,
frequency and instantaneous power (Vrms½, Arms½, W, Hz and scope waveforms for
Voltage, Amps, Watts).
Note: Power Wave records a long waveform while Scope Waveform displays 4 periods
of the momentary waveform.
Note: Power Wave is not available for measuremens in 400 Hz power systems such as
offered in Fluke 437-II.
Power Wave Screen
To access the Power Wave screen:
c
MENU
d
F2
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca
To Next Page
Loading...
Need help?
General
