Fluke 5520A - Page 16

5520A
Operators Manual
xii
5-4. Testing the RS-232 Host Port ................................................................................ 5-13
5-5. Testing the RS-232 UUT Port via RS-232 Host Port............................................. 5-18
5-6. Testing the RS-232 UUT Port via IEEE-488 Port ................................................. 5-20
5-7. IEEE-488 Remote Message Coding....................................................................... 5-25
5-8. Status Register Overview....................................................................................... 5-38
5-9. Status Byte and SRE Bit Definitions ..................................................................... 5-39
5-10. Event Status Register (ESR) and Event Status Enable (ESE) ............................... 5-41
5-11. Bit Assignments for the ISR, ISCEs and ISCRs .................................................... 5-43
7-1. Accessing the Fuse................................................................................................. 7-4
7-2. Accessing the Air Filter ......................................................................................... 7-6
8-1. Oscilloscope Connection: Channel and External Trigger...................................... 8-13
8-2. Tunnel Diode Pulser Connections.......................................................................... 8-21
8-3. Oscilloscope Connection: Channel and External Trigger...................................... 8-65
C-1. IEEE-488 Connector Pinout (connection side)...................................................... C-1
C-2. SERIAL 1 FROM HOST Port Connector Pinout .................................................. C-2
C-3. SERIAL 2 TO UUT Port Connector Pinout (connection side).............................. C-2
C-4. Serial Port Connections (DB-9/DB-9) ................................................................... C-3
C-5. Serial Port Connections (DB-9/DB-25) ................................................................. C-4