5520A
Operators Manual
3-16
to N to K
EOF (End of File) indicates the action taken at the end of a file by entering one or two ASCII
characters.
EOF (End of File) ASCII characters are entered with a range of 000 to 255 (first character) and 000
to 255 (second character). The factory defaults are 012,000, where the FF (form feed) character
signals an advance to the next page, and the NULL (ignore) character holds position. When the
NULL character is 000 (^@), then effectively the EOF is only the FF character, or ^L for the factory.
M
N
O
GPIB (General Purpose Interface Bus) selects the port address when using the IEEE-488 bus. The
factory default is 4.
to R to Q
DISPLAY BRIGHTNESS and DISPLAY CONTRAST apply to both the Output Display and Control
Display.
P
nn017f.eps
Figure 3-4. SETUP Softkey Menu Displays (cont)
To Next Page
Loading...
