EtherScope™ Series II
Getting Started Guide
4
• ES2-ITO-OPT: (Internetwork Throughput Option)
enables you to test the bandwidth available
between two nodes on a network. This option
enables the EtherScope Network Assistant to
generate a background traffic load to test new
systems and configuration or to simulate the impact
of additional users on a network.
• ES2-SX-OPT: enables the SFP fiber interface. Supports
1000BaseSX, 1000BaseLX, or 1000BaseZX fiber.
For information on these options, contact Fluke
Networks.
Package Contents
Take a moment to check the shipping container to make
sure that the contents match each numbered standard
accessory that is shown in Figure 1 and the accompanying
list in Table 1.
If any item is damaged, call the carrier at once for
inspection and request an inspection report. Please do
not write the factory until you have notified the carrier,
since this will delay your claim. If this precaution is not
taken, we cannot assist you in recovering the amount of
the claim against the carrier.
After you obtain the carrier's inspection report,
immediately return the instrument along with a copy of
the inspection report to the factory. See “Contacting
Fluke Networks” on page 13 for various ways to contact
us.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
