Fluke etherscope II - Instrument Settings-TCP;IP Screen; TCP;IP Settings

Network Assistant
Monitoring and Troubleshooting a Wired LAN
75
On this screen, you configure the instrument’s TCP/IP
settings:
epi86s.bmp
Figure 21. Instrument Settings—TCP/IP Screen
The hyperlinks in the preview pane take you to other
configuration screens, which are described in the sections
that follow.
TCP/IP Settings
If DHCP is available, the Instrument Settings—TCP/IP
screen (Figure 21) displays the address that the
instrument is able to obtain.
If you want to manually configure the IP address or
change the subnet mask, do the following:
Note
When manually assigning an IP address, you can
use an address for an alternate subnet but that
address must be in the same broadcast domain
as the EtherScope Network Assistant.
1. Clear the Automatically configure TCP/IP settings
checkbox to disable auto-configuration of the IP
settings.