11. Then, click the Load button to load the data into a Dispense List.
12. OPTIONAL: Go to the File menu, and select Import Dispense Data if you are not
satisfied with the way your current your experiment was imported. The software will
remember the choices you have made during the import process and allow you to
modify them as necessary. This option is applicable only if you have not restarted
the MANTIS software.
13. Click the Run Dispense button .
OR
Press F5.
Importing the experiment design data from the Reagent Name Based .CSV file
To import the dispense data from a Reagent Name Based file:
1. Go to the File menu, and select Import Dispense Data on the Import Dispense
Data menu.
2. Select Reagent Name Based and click Next.
MANTIS User's Guide | Chapter 9: Dispensing With the MANTIS
Selecting the Reagent Name Based
Note: If you choose a Continuous Flow chip and you have not calibrated your
reagents, the MANTIS Continuous Flow calibration window will appear after you
click the Load button. Follow the on-screen instructions to calibrate your chips. For
more information, see Calibrating Continuous Flow Chips on page 27.
To Next Page
Loading...