● Well Capacity: Determines the maximum well volume for your plate.
● Starting Volume: Determines the concentration volume of each well in your
experiment plate, before normalization.
Note: You cannot continue to the next step if your current settings cause diluent
volume overflow, which is shown in red in the bottom right of the wizard. To fix this,
you can adjust either the Specified Concentration value or the Well Capacity value
until no overflow is detected. Well Capacity as defined in the MANTIS software
should not exceed the actual maximum well volume for your plate.
Modifying the Plate Data
The Overflow Diluent Volume in Red
MANTIS User's Guide | Chapter 9: Dispensing With the MANTIS
To Next Page
Loading...