Fortinet FortiVoice 200D - Page 91

Fortinet Technologies Inc. Page 91 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
Variable Description Default
auto-configuration
{enable | disable}
Enable to auto-provision the SIP phones that use the
FortiVoice unit as the DHCP server.
The FortiVoice unit can auto provision the SIP phones
that it supports if the phones use the FortiVoice unit as
the DHCP server, or if other existing DHCP server is
used, then the DHCP server option 66 should be set to
the FortiVoice unit. In case the FortiVoice unit and the SIP
phone with an IP assigned by a DHCP server are on
different subnets, proper route should be set to make
them reachable.
For more information about auto provisioning, see
“system auto-provisioning” on page 82.
disable
<dhcp_id> Enter an ID for the DHCP server.
<ip_range_id> Enter the ID for the DHCP excluded IP range that should
not be assigned.
start-ip <ip_addr> Enter the start IP address of a range that this server
should not assign to the DHCP clients.
end-ip <ip_addr> Enter the end IP address of a range that this server
should not assign to the DHCP clients.
<ip_range_id> Enter the ID for the range of IP addresses that this DHCP
server assigns to DHCP clients.
start-ip <ip_addr> Enter the start IP address of a range that this DHCP
server assigns to DHCP clients.
end-ip <ip_addr> Enter the end IP address of a e that this DHCP server
assigns to DHCP clients.
<reserved_ip_id>
Enter the ID for an IP address from the DHCP server to
match it to a specific client using its MAC address.
ip <ip_addr>
Enter an IP address from the DHCP server to match it to
a specific client using its MAC address.
0.0.0.0
mac <mac_addr>
Enter the MAC address to match ip <ip_addr>.
00:00:00:
00:00:00
conflicted-ip-timeout
<int>
Enter the timeout in seconds. If an IP address assigned
by the DHCP server to a client conflicts with the IP
address of another client, the assigned IP address will be
released after the timeout and a new IP address will be
assigned.
1800
default-gateway
<ip_addr>
Enter the IP address of the default gateway that the
DHCP server assigns to DHCP clients.
192.168.2.9
9
dns-server1 <ip_addr>
Enter the IP address for the primary DNS server.
This option is available when you enter specify in dns-
service {default | specify}.
0.0.0.0
dns-server2 <ip_addr>
Enter the IP address for the secondary DNS server.
This option is available when you enter specify in dns-
service {default | specify}.
0.0.0.0