Fronius TransSteel 2200 - Setup Menu Level 2 Parameters

Setup Menu 2nd Level
Accessing and
exiting the 2nd
level of the Setup
menu, changing
parameters
Accessing the 2nd level of the Setup menu:
1
Press the "Process" button to select the
"MIG/MAG standard synergic welding"
process
+
2
The control panel is now located in the
Setup menu of the "MIG/MAG standard
synergic welding" process - the last selec-
ted setup parameter is displayed.
3
Select the "2nd" setup parameter using the
left-hand selection dial
+
4
The control panel is now located in the
2nd level of the Setup menu of the
"MIG/MAG standard synergic welding"
process - the last selected setup para-
meter is displayed.
To change a parameter:
1
Select the desired setup parameter using
the left-hand selection dial
Change the setup parameter value using
the right-hand selection dial
To exit the Setup menu:
+
1
A parameter is displayed in the first level
of the Setup menu.
+
2
A parameter is displayed in the first level
of the Setup menu.
Parameters for
MIG/MAG stand-
ard manual weld-
ing
SEt Country-specific setting (Standard/USA) ... Std/US
Unit: -
Setting range: Std, US (Standard/USA)
Factory setting:
Standard device: Std (measurements in cm/mm)
100