Adjusting the
brake of the D200
wirespool holder
CAUTION!
Danger from emerging wire electrode and moving parts.
Personal injury and damage to property may result.
▶
Before starting work, turn the mains switch of the power source to - O - and discon-
nect the power source from the mains
▶
Secure all devices and components involved so they cannot be switched back on.
To adjust the brake:
1
- Turn the brake to the right = increase
braking force
- Turn the brake to the left = decrease
braking force
Adjusting the
brake of the D100
wirespool holder
CAUTION!
Danger from emerging wire electrode and moving parts.
Personal injury and damage to property may result.
▶
Before starting work, turn the mains switch of the power source to - O - and discon-
nect the power source from the mains
▶
Secure all devices and components involved so that they cannot be switched back
on.
Adjust the brake:
1
Tighten the knurled screw (1)
- Knurled screw fully tightened =
high braking force
- Knurled screw slightly tightened =
low braking force
61
EN-US
To Next Page
Loading...
