Fronius TransSteel 2200 - Adjusting the Brake of the Wirespool Holders; General

Adjusting the Brake of the Wirespool Holders
General D200 wirespool holder:
Adjust the brake when using the wirespool holder for the first time and after changing the
wirespool. To do so, proceed as described in the following section Adjusting the brake
of the D200 wirespool holder.
D100 wirespool holder:
Adjust the brake when using the wirespool holder for the first time and after changing the
wirespool. To do so, proceed as described in the following section Adjusting the brake
of the D100 wirespool holder
After releasing the torch trigger (end of
welding, end of wirefeeding), the wirespool
must stop unreeling.
If it fails to do so, adjust the brake.
60