When the power source is reset, the majority of the applied settings are deleted.
The following values remain:
- Welding circuit resistance and welding circuit inductivity
- Country-specific setting
2nd Second level of the Setup menu (see "Setup Menu 2nd Level")
Parameters for
TIG welding
F-P Pulse frequency
Unit: Hertz
Setting range: OFF; 1 - 990
(up to 10 Hz: in 0.1 Hz increments)
(up to 100 Hz: in 1 Hz increments)
(over 100 Hz: in 10 Hz increments)
Factory setting: OFF
tUP UpSlope
Unit: seconds
Setting range: 0.01 - 9.9
Factory setting: 0.5
tdo DownSlope
Unit: seconds
Setting range: 0.01 - 9.9
Factory setting: 1
I-S Starting current
Unit: % of main current
Setting range: 1 - 200
Factory setting: 35
I-2 Lowering current
Unit: % of main current
Setting range: 1 - 100
Factory setting: 50
I-E Final current
Unit: % of main current
Setting range: 1 - 100
Factory setting: 30
GPo Gas post-flow time
Unit: seconds
Setting range: 0 - 9.9
Factory setting: 9.9
tAC Tacking
Unit: seconds
Setting range: OFF, 0.1 - 9.9
Factory setting: OFF
FAC Reset power source to factory settings
Press and hold one of the "Parameter selection" buttons for two seconds to
restore the factory settings
- when "PrG" appears on the digital display, the power source has been reset.
98
To Next Page
Loading...
