Fronius TransSteel 2200 - Parameters for MIG;MAG Standard Synergic Welding

Ito Length of wire that is fed before the safety cut-out trips
Unit: mm (in.)
Setting range: OFF, 5 - 100 (OFF, 0.2 - 3.94)
Factory setting: OFF
The ignition time-out function (Ito) is a safety feature.
If the power source determines that no ignition has occurred after the preset wire
length has been fed, wirefeeding is stopped.
SPt Spot welding time
Unit: seconds
Setting range: OFF, 0.3 - 5
Factory setting: 1
SPb Spot pause time
Unit: seconds
Setting range: OFF, 0.3 - 10 (in 0.1 s increments)
Factory setting: OFF
Int Interval
Unit: -
Setting range: 2T (2-step), 4T (4-step)
Factory setting: 2T (2-step)
FAC Reset power source to factory settings
Press and hold one of the "Parameter selection" buttons for two seconds to
restore the factory settings
- when "PrG" appears on the digital display, the power source has been reset
When the power source is reset, the majority of the applied settings are deleted.
The following values remain:
- Welding circuit resistance and welding circuit inductivity
- Country-specific setting
2nd Second level of the Setup menu (see "Setup Menu 2nd Level")
Parameters for
MIG/MAG stand-
ard synergic
welding
GPr Gas pre-flow time
Unit: seconds
Setting range: 0 - 9.9
Factory setting: 0.1
GPo Gas post-flow time
Unit: seconds
Setting range: 0 - 9.9
Factory setting: 0.5
SL Slope
Unit: seconds
Setting range: 0 - 9.9
Factory setting: 1
I-S Starting current
Unit: % of welding current
96