General
Device concept The TransSteel (TSt) 2200 power source
is a completely digitized, microprocessor-
controlled power source.
This power source is designed for the
welding of steel and can be used for the
following welding processes:
- MIG/MAG welding
- SMAW
- TIG welding with touch-down ignition
The central control and regulation unit of the power source is coupled with a digital signal
processor. The central control and regulation unit and signal processor control the entire
welding process.
During the welding process, the actual data is measured continuously and the device
responds immediately to any changes. Control algorithms ensure that the desired target
state is maintained.
"Power limita-
tion" function
The power source has a "Power limitation" safety feature.
This function is only available for the MIG/MAG standard synergic welding process.
Mode of operation:
If necessary, the power source reduces the welding power to prevent the arc from being
extinguished during welding at the power limit of the power source. The reduced para-
meters are displayed on the control panel until welding starts again or until the next para-
meter change.
This results in:
- A more precise welding process
- A high degree of reproducibility of all results
- Exceptional weld properties
As soon as the function is active, the indicator for the wire speed parameter on the con-
trol panel flashes.
The flashing continues until the next welding start-up, or until the next parameter change.
21
EN-US
To Next Page
Loading...
