Fronius TransSteel 2200 - Managing Saved Welding Jobs (EasyJobs)

Saving and Retrieving EasyJobs
General - The "Save" buttons allow two EasyJobs to be saved
- The adjustable parameters on the control panel are saved
- Setup parameters are not saved at this time
Saving an Easy-
Job
1
Press and hold one of the "Save" buttons to save the current settings on the control
panel, e.g., Number 1
- The left indicator displays "Pro"
- After a short time, the left indicator switches to the original value
2
Release the "Save" button
Retrieving an
EasyJob
1
To retrieve saved settings, press the corresponding "Save" button briefly, e.g., Num-
ber 1
- The control panel will show the saved settings
Deleting an Easy-
Job
1
Press and hold the relevant "Save" button to delete the memory content of that
"Save" button, e.g., Number 1
- The left indicator displays "Pro"
- After a short time, the left indicator switches to the original value
2
Keep the "Save" button held down
- The left indicator displays "CLr"
- After a while, both indicators display "---"
3
Release the "Save" button
91
EN-US