Fronius TransSteel 2200 - MIG;MAG Standard Synergic Welding

MIG/MAG Standard Synergic Welding
MIG/MAG stand-
ard synergic
welding
1
Press the "Process" button to select SYNERGIC
2
Press the "Mode" button
to select the desired MIG/MAG mode:
2-step mode
4-step mode
S 4 T = Special 4-step mode
Spot welding/stitch welding
Under certain circumstances, it may not be possible to change welding parameters
that have been set for a system component (remote control, etc.) on the control
panel of the power source.
3
Press the "Material" button to select the filler metal being used
4
Press the "Wire diameter" button to select the diameter of the wire electrode being
used
5
Press the "Shielding gas" button to select the shielding gas being used
6
Press the "Parameter selection" buttons
to select the welding parameter with which the welding power is to be specified:
Sheet thickness
Welding current
Wire speed
Welding voltage
7
Set the welding parameters
All parameter set values remain stored until the next time they are changed. This applies
even if the power source is switched off and on again.
8
Ensure that the ground earth connection has been established
9
Ensure that the shielding gas supply has been established
- Power source is ready for welding
69
EN-US