Fronius TransSteel 2200 - Keylock and Parameter Selection Controls

Keylock A keylock can be activated to prevent the settings from being inadvertently changed on
the control panel. As long as the keylock is active:
- Settings cannot be adjusted on the control panel
- Parameter settings can be displayed
- It is possible to switch between EasyJobs if an EasyJob was selected before the
keylock was activated
Activating/deactivating the keylock:
+
1
Keylock activated:
The message "CLO | SEd" appears on the
displays.
Keylock deactivated:
The message "OP | En" appears on the
displays.
37
EN-US