Fronius TransSteel 2200 - Parameters for MMA Welding

When the power source is reset, the majority of the applied settings are deleted.
The following values remain:
- Welding circuit resistance and welding circuit inductivity
- Country-specific setting
2nd Second level of the Setup menu (see "Setup Menu 2nd Level")
Parameters for
MMA Welding
HCU HotStart current
Unit: %
Setting range: 100 - 200
Factory setting: 150
Hti Hot current time
Unit: seconds
Setting range: 0 - 2.0
Factory setting: 0.5
Ast Anti-stick function
Unit: -
Setting range: On, OFF
Factory setting: On
FAC Reset power source to factory settings
Press and hold one of the "Parameter selection" buttons for two seconds to
restore the factory settings
- when "PrG" appears on the digital display, the power source has been reset.
When the power source is reset, the majority of the applied settings are deleted.
The following values remain:
- Welding circuit resistance and welding circuit inductivity
- Country-specific setting
2nd Second level of the Setup menu (see "Setup Menu 2nd Level")
99
EN-US