EnE Real Energy Input – electrical energy of the arc relative to the welding
speed
Unit: kJ
Setting range: ON / OFF
Factory setting: OFF
Since the full range of values (1 kJ - 99999 kJ) cannot be displayed on
the three-digit display, the following display format has been selected:
Value in kJ / indicator on display:
1 to 999 / 1 to 999
1000 to 9999 / 1.00 to 9.99 (without "ones" digit, e.g. 5270 kJ -> 5.27)
10000 to 99999 / 10.0 to 99.9
(without "ones" and "tens" digits, e.g. 23580 kJ -> 23.6)
ALC Arc Length Correction - correction of the arc length via the welding
voltage
Setting range: ON / OFF
Factory setting: OFF
The arc length depends on the welding voltage. The welding voltage can
be adjusted to suit individual needs in Synergic operation.
If the ALC parameter is set to "OFF", the welding voltage cannot be ad-
justed. The welding voltage is automatically determined by the selected
welding current or wire speed. If the arc length correction is adjusted,
the voltage changes, but the welding current and wire speed remain the
same. When setting the arc length correction using the adjusting dial,
the left display is used for the correction value of the arc length. The
welding voltage value on the right display changes simultaneously. Af-
terwards the left display shows the original value, e.g. welding current.
100
To Next Page
Loading...
