Ejt EasyJob Trigger - for activating / deactivating the switching of Easy-
Jobs by means of the torch trigger
Unit: -
Setting range: ON / OFF
Factory setting: OFF
Function with MIG/MAG torch trigger
Press torch trigger briefly (< 0.5 s)
No welding operation:
-
All MIG/MAG EasyJobs are switched through in succession.
-
If no EasyJob is selected, the torch trigger functions normally.
-
If no MIG/MAG EasyJob is selected, no change is made.
During welding:
-
Switching through MIG/MAG EasyJobs with the same operating
mode (4-step, special 4-step mode, 4-step stitch welding) and with
the same welding process.
-
Switching is not possible during spot welding.
Function with MIG/MAG Up/Down button
-
If EasyJob is selected, the EasyJob is changed; otherwise the weld-
ing current is changed.
No welding operation:
-
All MIG/MAG EasyJobs are switched through in succession.
During welding:
-
Switching through MIG/MAG EasyJobs with the same operating
mode (2-step, 4-step, special 4-step mode, 4-step stitch welding)
and with the same welding process.
-
Switching back is possible.
Parameters for
manual metal
arc (MMA) weld-
ing in the Setup
menu level 2
r r (resistance) - welding circuit resistance (in mOhm)
See "Measuring welding circuit resistance r" from page 102.
L L (inductivity) - welding circuit inductivity (in microhenry)
see "Displaying welding circuit inductivity L" from page 104.
101
EN
To Next Page
Loading...
