INF-TN1FSC-E 111
(4) Set “ERROR TIMER”
Setting range: 0 to 900sec
Select “ERROR TIMER” by pressing the
or
key.
Press the
ENT
key, and you are ready to set the time.
(5) Move the digit by the
or key and enter numeric
values by pressing the
or key.
After entry, press the
ENT
key.
• HOLD: Holds output indications before the
occurrence of errors.
• UPPER: 10.4.2(1) the setting of "Output limit
high" is output.
• LOWER: 10.4.2(1) the setting of "Output limit
high" is output.
• ZERO: Outputs (0%, 4 mA) at zero point
To Next Page
Loading...
