INF-TN1FSC-E 137
(3) Detail setup
Set measuring conditions.
Point the cursor to “DETAILS” by pressing
, key, and then press the
ENT
key.
(1) Sensor type
Point the cursor to “SENSOR TYPE” by using the
, key and press the
ENT
key.
Select the type of sensors to be used.
(2) Sensor source
Point the cursor to “SENSOR SOUCE” by using the
, key and press the
ENT
key.
Set connection between the sensor and conversion
unit's connector.
Use the upstream side, normally in case one measur-
ing line. (Sensor U)
In case of two measuring lines, use both of upstream
side and downstream side. (Sensor U/D)
Make selection corresponding to the connection.
(3) Display selection
Point the cursor to “KIND” by using the
, key
and press the
ENT
key.
Either fl uid velocity or fl ow rate is displayed together
with fl ow velocity distribution.
Select the item to be displayed.
To Next Page
Loading...
