MHT258a (Engl.)7-19
7.6 Positioning data edit mode
* For RYS-V type, positioning data edit mode is invalid.
(Mode indication is only.)
7.7 Test running mode
In the test running mode, keying on the keypad panel can rotate the motor or reset the different items.
Upon displaying [ ] by the MODE key, holding down the ENT key for at least 1 [sec] executes a test running.
: Manual feed : Initializing the history
: Origin return : Initializing the paras.
: Position preset : Initializing the positioning data
: Alarm reset : Automatic offset addjust
(1) Manual feed (
)
So long as a key on the keypad panel is pressed, the motor rotates. The motor speed is as set by basic para. 1.
* So long as ∧ key or ∨ key is pressed, the motor rotates
While the motor is rotating by a control input/output signal,
other indication than [ ] cannot be selected.
(2) Origin return ( )
Keying on the keypad panel performs an origin return. The origin return is made according to basic paras. 71 to 79. Change of basic para.
71 to 73 settings is effective only after turning off and on power.
After the end of origin return, the indication remains [ ]. Pressing the ESC key resumes a sub-mode selection.
ENT (1s or more)
ESC
ENT
ESC
ENT (1s or more)
ESC
ENT
ESC
∧
∨
Indicates rotating in negative direction
Indicates rotating in positive direction
ENT
ESC
Return end
To Next Page
Loading...