Fuji Electric RYS...S3-VVS Series - Page 192

MHT258a (Engl.)8-5
(2) Test running mode
By the touch panel of amplifier, rotate the motor.
Select the test running mode.
Key input LC display (example) Remark
Example of sequence mode display.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
ESC key resumes selecting the mode.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
The monitor mode is posted.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
The para. edit mode is posted.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
The positioning data edit mode is posted.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
The test running mode is posted.
SHIFT
SHIFTSHIFT
SHIFT
ENT
ENTENT
ENT
Pressing the ENT key for at least 1 [sec] can execute manual feed.
SHIFT
SHIFTSHIFT
SHIFT
ENT
ENTENT
ENT
By pressing the ENT key, motor can be rotated.
Holding down the ∨ key rotates the motor forward (＊).
Releasing the key stops motor.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
Pressing the ESC key resumes selecting the mode.
Remark : In case of a vertical-feed load machine such as elevator, a motor with provided brake is applied.
In this case, the brake release and excitation must be performed according to keying in the test running mode.
For brake timing, use the control output signal “brake timing”.
(＊) Direction of motor shaft rotation (when viewed from a point facing the drive-end of motor) is designed according to Japanese standards :
• Forward direction : Counter-clockwise (CCW) rotation
• Reverse direction : Clockwise (CW) rotation