Fuji Xerox DocuCentre-IV 2060 Administrator's Guide

Error Code
425
Problem Solving
15
016-598
016-599
[Cause] The size of an e-mail page exceeds the maximum message size because of
page splitting.
[Remedy] Take one of the following measures:
z
Reduce the file size for [Quality/File Size].
z
Increase the value for [Maximum Split Count].
For more information on [Quality/File Size], refer to "5 Scan" > "E-mail Options/Filing Options"
> "Quality/File Size (Specifying an Image Compression Ratio When Scanning)" in the User
Guide.
For more information on [Maximum Split Count], refer to "Maximum Split Count" (P.195).
016-700
[Cause] The job was suspended because the number of the digits for the Secure Print
or Charge Print passcode set on the print driver was less than the value
specified in [Minimum Passcode Length for Stored Job] on the machine.
[Remedy] On the print driver, set the passcode string equal to or longer than the value
specified in [Minimum Passcode Length for Stored Job].
016-701
[Cause] Unable to process print data because of insufficient memory.
[Remedy] Stop unnecessary ports or delete unnecessary data to increase memory.
016-702
[Cause] Unable to process print data because of insufficient print page buffer.
[Remedy] Take one of the following measures:
z
Set [Image Quality] to [Standard].
z
Increase the print page buffer size.
z
Add memory.
For more information on the [Image Quality], refer to the help of the print driver. For more
information about memory, refer to "Allocate Memory" (P.169).
016-703
[Cause] The machine received e-mail which specified an invalid folder number.
[Remedy] For errors occurring during fax or Internet fax transmission:
Contact our Customer Support Center.
For errors occurring during e-mail/fax/Internet fax reception:
Take one of the following measures:
z
Register the specified folder number, and request the sender to send the e-
mail/fax/Internet fax again.
z
Request the sender to send to an available folder.
If the error still is not resolved, contact our Customer Support Center.
016-704
[Cause] The folder is full, and hard disk capacity is insufficient.
[Remedy] Delete unnecessary files from the folder, and save the file.
Refer to "6 Send from Folder" > "Checking/Operating Files in a Folder" in the User Guide.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Downloaded From ManualsPrinter.com Manuals

Fuji Xerox DocuCentre-IV 2060 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV 2060
Category	All in One Printer
Language	English